16/11/2026

Cost-Effective 5G RedCap Router for Surveillance: How Many Cameras RedCap Can Carry, What It Costs per Site, and When 4G or Full 5G Is the Better Buy

  • This topic is empty.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • #13134
    admin
    Keymaster

      Surveillance projects multiply every hardware decision. A router that costs a little more per unit becomes a significant line item across fifty, two hundred, or a thousand camera sites. That is why 5G RedCap has attracted so much interest from integrators and operators of camera networks: it promises access to 5G networks at a lower cost and power than full 5G.

      Whether RedCap is the cost-effective choice for a particular surveillance project depends on how many cameras each site has, how video is recorded, whether 5G standalone coverage exists, and how much a site failure costs. This article works through each of those questions, sets out E-Lins RedCap pricing alongside its 4G and full 5G ranges, and shows how to compare costs per site rather than per router.

      What RedCap Brings to a Camera Site

      5G RedCap (Reduced Capability) was introduced in 3GPP Release 17 for devices that do not need the full performance of 5G. Compared with a full 5G device, a RedCap device uses a narrower channel bandwidth, fewer receive antennas, and a simpler radio, which reduces cost, power consumption, and design complexity. Its achievable speeds are well below full 5G and broadly comparable to mid-range LTE categories, but it connects to the 5G standalone network and benefits from its newer core features and longer technology horizon.

      For surveillance, the most important point is the uplink. Camera sites mainly send data, and a RedCap device has a single transmit chain. That is plenty for a few cameras recording locally and sending events and live views, but not for many continuous high-resolution streams.

      How Many Cameras Can RedCap Carry?

      The answer depends far more on the recording strategy than on the camera count:

      Local recording, event upload and occasional live view: the network carries only alerts, short clips and the views operators actually open. A RedCap router can serve a typical small site, such as a gate, a substation fence or a car park entrance with a few cameras.

      Continuous streaming of one or two cameras to a cloud recorder: possible where measured upload speed at the site is comfortably above the combined bitrate, with margin for busy hours.

      Continuous streaming of several high-resolution cameras, or a site that also aggregates other traffic: this is full 5G territory.

      Always measure upload speed at the actual mounting position, on each available operator’s standalone network, before committing a site type to RedCap.

      E-Lins Pricing Across the Three Tiers

      E-Lins gives reference price ranges for its router tiers:

      Tier

      E-Lins reference price per unit

      Typical surveillance fit

      4G industrial router

      $65 to $120

      Sites with light video and no 5G standalone coverage

      5G RedCap router

      $140 to $160

      Small camera sites with local recording on standalone 5G

      Full 5G router

      $180 to $220

      Multi-camera sites with continuous streaming or aggregation

      Optional features add modestly to the base price: E-Lins lists GPS at about $10, RS485 at about $5, and wide-voltage input at about $10. E-Lins states that focused product lines and scaled supply chain management allow it to deliver professional quality at mid-range cost, typically 20% to 40% more affordable than other professional manufacturers. Final quotations depend on configuration and volume.

      Cost per Site, Not Cost per Router

      Using the reference ranges above, the difference between a RedCap router and a full 5G router is roughly $20 to $80 per unit, and the difference between a RedCap router and a 4G router is roughly $20 to $95. Across a 50-site rollout, choosing RedCap instead of full 5G saves somewhere between $1,000 and $4,000 in router hardware.

      Those are real savings, but they need to be weighed against the other costs of a camera site:

      Data plans, which depend on the recording strategy far more than on the router tier.

      Installation, which is the same whichever router is chosen.

      Site visits, where a single unplanned trip to a remote pole can cost more than the hardware difference between tiers.

      Lifetime, where a router that stays current on its network for longer delays the next replacement project.

      The cost-effective choice is the tier that meets each site’s real traffic with the fewest visits over the longest life, not automatically the cheapest unit.

      Choosing Among E-Lins RedCap Models for Surveillance

      H685frc: a compact RedCap router with two Gigabit Ethernet ports, PoE In, Wi-Fi, an RS232 port, four DI/DO, and DIN-rail mounting, for a single-camera or small cabinet site powered from a PoE switch.

      H820frc: five Gigabit Ethernet ports with PoE In or PoE Out variants, RS232, DI/DO, and SD-WAN, for sites where the router should power a camera directly or connect several devices.

      H900frc: dual SIM, three Gigabit and two Fast Ethernet ports, PoE In and RS232, for camera sites that must stay online when one operator has problems.

      H685frc-G and H900frc-G: RedCap with GPS, suited to mobile camera trailers and temporary towers whose position must be tracked.

      H900pfrc: a RedCap modem with dual SIM and 4G failover, for sites where standalone 5G coverage is not yet reliable everywhere.

      Digital inputs on these models are useful for cabinet door contacts and tamper switches, so the monitoring centre is alerted when someone opens the box, not only when the video stops.

      Where Saving Money Costs More

      Choosing RedCap where there is no standalone coverage. RedCap needs a 5G standalone network. Where operators only offer non-standalone 5G, a RedCap router falls back to 4G if the model supports it, and the 5G advantage disappears.

      Skipping dual SIM at critical sites. A camera at a site that must never go dark justifies the second SIM many times over.

      Using consumer equipment in cabinets. Heat, unstable power, and the lack of remote recovery turn small savings into repeated visits.

      Sending everything to the cloud. A recording strategy that streams continuously can cost more in data each year than the router itself.

      Industrial Baseline Included in the Price

      Every E-Lins RedCap router is built on the same industrial baseline as its other routers: components rated from -35°C to +75°C, 15KV ESD protection and 1.5KV electromagnetic isolation, hardware watchdog timers and link self-healing, VPN support including WireGuard, IPsec and OpenVPN, and management through TR-069, SNMP, SSH and the E-Lins NMS cloud platform. Firmware is developed in-house and upgraded free for life, which matters for camera networks that must stay secure for years.

      The Manufacturer

      Shenzhen E-Lins Technology Co., Ltd. has supplied industrial cellular routers since its industrial roots in 1999, released 5G NR industrial routers from 2019, and now offers RedCap as a distinct tier between its 4G and full 5G products, serving customers in more than 150 countries and regions. For surveillance projects, a cost-effective 5G RedCap router is the one matched to each site’s cameras, recording strategy, and coverage; on that basis, RedCap is often the best value in the range.

      https://e-lins.com/
      Shenzhen E-Lins Technology Co., Ltd.

    Viewing 1 post (of 1 total)
    • You must be logged in to reply to this topic.